and repair according to Sec. 63.104(f)(1).

----------------------------------------------------------------------------------------------------------------

Table 6 to Subpart UUUU of Part 63.--Continuous Compliance With Operating

Limits [As required in Sec. 63.5555(a), you must demonstrate continuous

compliance with the appropriate operating limits according to the

requirements in the following table:]

------------------------------------------------------------------------

you must demonstrate For the following control for the following continuous

technique . . . operating limit . . compliance by . . .

----------------------------------------.------------------------------- 1.

condenser................ maintain the daily collecting the average

condenser condenser outlet outlet gas or gas or condensed condensed liquid

liquid temperature temperature no data according to higher than the Sec.

63.5545; value established reducing the during the condenser outlet

compliance gas temperature demonstration. data to daily averages; and

maintaining the daily average condenser outlet gas or condensed liquid

temperature no higher than the value established during the compliance

demonstration. 2. thermal oxidizer......... maintain the daily collecting

the average thermal thermal oxidizer oxidizer firebox firebox temperature

temperature no data according to lower than the Sec. 63.5545; value

established reducing the during the thermal oxidizer compliance firebox

temperature demonstration. data to daily averages; and maintaining the

daily average thermal oxidizer firebox temperature no lower than the value

established during the compliance demonstration. 3. water

scrubber........... maintain the daily collecting the average scrubber

scrubber pressure pressure drop and drop and scrubber scrubber liquid

liquid flow rate flow rate within data according to the values Sec.

63.5545; established during reducing the the compliance scrubber parameter

demonstration. data to daily averages; and maintaining the daily scrubber

parameter values within the values established during the compliance

demonstration. 4. caustic scrubber......... maintain the daily collecting

the average scrubber scrubber pressure pressure drop, drop, scrubber

scrubber liquid liquid flow rate, flow rate, and and scrubber liquid

scrubber liquid pH, pH, conductivity, conductivity, or or alkalinity data

alkalinity within according to Sec. the values 63.5545; reducing

established during the scrubber the compliance parameter data to

demonstration. daily averages; and maintaining the daily scrubber parameter

values within the values established during the compliance demonstration.

5. flare.................... maintain the collecting the pilot presence of

a pilot flame data flame. according to Sec. 63.5545; and maintaining the

presence of the pilot flame. [[Page 40089]] 6. biofilter................

maintain the daily collecting the average biofilter biofilter inlet gas

inlet gas temperature, temperature, biofilter effluent biofilter effluent

pH, and biofilter pH, and pressure pressure drop data drop within the

according to Sec. values established 63.5545; reducing during the the

biofilter compliance parameter data to demonstration. daily averages; and

maintaining the daily biofilter parameter values within the values

established during the compliance demonstration. 7. carbon

absorber.......... maintain the collecting the data regeneration on

regeneration frequency, total frequency, total regeneration stream

regeneration stream mass or volumetric mass or volumetric flow during

carbon flow during carbon bed regeneration bed regeneration and temperature

of and temperature of the carbon bed the carbon bed after regeneration

after regeneration (and within 15 (and within 15 minutes of minutes of

completing any completing any cooling cycle(s)) cooling cycle(s)) for each

for each regeneration cycle regeneration cycle within the values according

to Sec. established during 63.5545; and the compliance maintaining carbon

demonstration. absorber parameter values for each regeneration cycle within

the values established during the compliance demonstration. 8. oil

absorber............. maintain the daily collecting the average absorption

absorption liquid liquid flow, flow, absorption absorption liquid liquid

temperature, temperature, and and steam flow data steam flow within

according to Sec. the values 63.5545; reducing established during the oil

absorber the compliance parameter data to demonstration. daily averages;

and maintaining the daily oil absorber parameter values within the values

established during the compliance demonstration. 9. any of the control if

using a CEMS, collecting CEMS techniques specified in maintain the daily

emissions data at this table. average control the inlet and efficiency for

each outlet of each control device no control device lower than the

according to Sec. value established 63.5545; during the determining the

compliance control efficiency demonstration. values for each control device

using the inlet and outlet CEMS emissions data; reducing the control

efficiency values for each control device to daily averages; and

maintaining the daily average control efficiency for each control device no

lower than the value established during the compliance demonstration.

------------------------------------------------------------------------

Table 7 to Subpart UUUU of Part 63.--Notifications [As required in

63.5490(c)(4), 63.5530(c), 63.5575, and 63.5595(b), you must submit the

appropriate notifications specified in the following table]

------------------------------------------------------------------------ If

you . . . then you must . . .

------------------------------------------------------------------------ 1.

are required to conduct a submit a notification of intent to performance

test. conduct a performance test at least 60 calendar days before the

performance test is scheduled to begin, as specified in Secs. 63.7(b)(1)

and 63.9(e). 2. wish to use an alternative submit a request to use

alternative monitoring method. monitoring method no later than the

notification of the initial performance test or CEMS performance evaluation

or 60 days prior to any other initial compliance demonstration, as

specified in Sec. 63.8(f)(4). 3. start up your affected submit an initial

notification no later source before June 11, 2002. than 120 days after June

11, 2002, as specified in Sec. 63.9(b)(2). 4. start up your new or submit

an initial notification no later reconstructed source on or than 120 days

after you become subject after June 11, 2002. to this subpart, as specified

in Sec. 63.9(b)(3). 5. cannot comply with the submit a request for

extension of relevant standard by the compliance no later than 120 days

applicable compliance date. before the compliance date, as specified in

Secs. 63.9(c) and 63.6(i)(4). 6. are subject to special notify the

Administrator of your requirements as specified in compliance obligations

no later than Sec. 63.6(b)(3) and (4). the initial notification dates

established in Sec. 63.9(b) for new sources not subject to the special

provisions, as specified in Sec. 63.9(d). 7. are required to conduct notify

the Administrator of the visible emission observations anticipated date for

conducting the to determine the observations anticipated date for

conducting the